Water Dragon Universal Outlet

Sport and Explorer Pro install (Outlet)
-
Installing the outlet on the Sport and Explorer Pro will require an additional hole to be drilled through your hull. If you are not confident in this step, please seek professional assistance. Whilst all tools and instructions are provided with our kits, we accept no liability for any damage you may cause to your watercraft as a result of an incorrect installation.
-
Prior to starting the below, should your Watercraft have any aftermarket accessories installed in the hull that may interfere with the location of the Water Dragon outlet, please take extra care to ensure that drilling in the locations indicated below will not damage these accessories in any way.
-
STEP 1
-
Using the provided drill template and 2.8mm (7/64") dill bit provided.
Carefully align the template on your watercraft as indicated below, taking note of the arrow and writing orientation, this is viewed when standing at the rear of the watercraft.
Drill 3x holes through the pilot holes indicated by the red arrows on the template. The holes must be drilled all the way through the hull.
-
STEP 2
-
Using the 25mm TCT hole saw provided in the kit, align the pilot drill with the middle hole you drilled earlier and make the center hole for the pipe. Start slowly at first to allow the hole saw to cut the initial starter groove to avoid slipping.
-
STEP 3
-
Feed the attached hose on the outlet through the hole, and snug down the outlet using the 2x stainless steel self tapping screws provided.
TOP TIP: 
Spray some WD40 on the screw threads before inserting them to make tightening them a little easier. Be sure to press down on the screwdriver with more force than you turn with to avoid stripping the screw heads. Go slow!
-

You are all set to attach the hose end to your favorite pump with 19mm outlet!
-
Original Creative Designs accepts no responsibility or liability for damage or losses as a result of the use of our products.