Rhino Mount ©

Installing the Rhino Mount

The must have Rhino Mount provides a super convenient secure spot to mount your GoPro © or Railblaza © lighting system, up front, where it belongs.

The mount is designed to be installed using the 2x factory screws located on the front binnacle as per the image below.

The Rhino Mount is suitable for Seadoo FishPro Trophy ©, Fishpro Sport ©, GTX and RXTX models. 

It is designed to remain on the watercraft, and will not obstruct the opening of your front hatch. Care has been taken to test the mount on the above models, however, it is advised to take extra care when opening your front storage hatch for the first time after installing your new Rhino Mount, to ensure it has the appropriate clearance as pictured below, when fully open.

Worn or damaged hinges, struts or mounting points could effect the opening distance of your front hatch so please ensure the above step is carefully followed.

Your Rhino Mount comes complete with a 30cm tether that can be attached to your RailBlaza camera mount adapter ©. If you choose to make use of the tether, simply pass the end of the cord through the hole located on the bottom of your Rhino Mount pictured below, and tie off with a single knot, ensuring the knot is pulled snug. Take the loop end of the tether and pass over the center fingers of your Railblaza camera mount adapter © prior to installing your camera.

 

 

To install your Rhino Mount, carefully remove the 2x factory screws holding the front binnacle in place, using the appropriate sized Torx © head screwdriver.

Install your new Rhino Mount in place and re install the factory screws, making sure not to over tighten.

It is strongly advised to only use hand tools to attach your Rhino Mount as cordless power tools may result in damage to the Rhino Mount and your Watercraft.

You are set for your next adventure, simply install your favorite Railblaza © accessory and hit the water!