Warthog Mount ©
Installing the Warthog Mount
Our awesome Warthog Mount is designed to be mounted conveniently to the rear of your LinQ © Cooler, providing a great place to mount a second GoPro,
RailBlaza © lighting system, or any other lightweight accessories you choose.
To install the Warthog Mount, simply remove the 2x factory screws located on the top rod holder rail as pictured below using a suitable Torx © head screwdriver
Use hand tools only to avoid damage
Install the upper and lower half of your Warthog Mount, as per the image above.
Take note that the lower half of the mount must be installed with the bolt hole facing away from the cooler, as per the image below.
Install the provided stainless steel bolt and washer, do not tighten fully at this stage. Re install the factory screws and tighten by hand, making sure not to over tighten.
Do not use cordless or impact drivers to tighten the screws as you risk damaging both the Warthog Mount and your LinQ cooler.
Once you have tightened the factory screws, you can then proceed to snug down the stainless steel bolt in the Warthog Mount with a 3mm hex spanner to ensure a secure fit that will not come loose, even in the harshest conditions.
Do not over tighten the stainless steel bolt it has a nyloc nut installed in the lower half of the mount and only requires snugging down onto the stainless steel washer provided.
With a Gopro © mounted using the standard Railblaza © camera mount, you are still able to fully open your LinQ © cooler lid without obstruction.
Installing any other accessories that extend beyond this should be done with caution to avoid damaging them, or your LinQ © cooler when opening the lid.
Not recommended for rod holders or downriggers.
All that is left to do now is mount your favorite accessories to your Railblaza © compatible Warthog Mount and enjoy the open waters on your next adventure!